Wizard 700 Series Serial Cables

• The cable that comes with a 700 series wizard looks roughly like this:

  				Purpose	Connects to
  				Data <<	pin 3
  				Data >>	pin 2	(5) (4) (3) (2) (1)
  				DTR (trigger sync mode)	pin 4	(9) (8) (7) (6)
  				Ground	pin 5

• To make up your own cable, put a 9-pin plug on the end of a stereo 3.5mm moulded-plug cable:

  				Purpose	Connects to
  				Left channel (yellow wire)	pin 3
  				Right Channel (red wire)	pin 2	(5) (4) (3) (2) (1)
  						(9) (8) (7) (6)
  				Ground	pin 5

  (You'll have to cut away about 4mm of plastic from the plug so that it will fit into the wizard)
  - Note that the organizer won't automatically go into sync mode with this cable - you'll have to use 2nd-MENU to enter sync mode.

• To plug your wizard into a modem, use the following cable:

  				Purpose	Connects to
  				Left channel (yellow wire)	pin 2
  				Right Channel (red wire)	pin 3	(1) (2) (3) (4) (5)
  						(6) (7) (8) (9)
  				Ground	pin 5
  					also connect pin 4 to pin 6